All you need in water proofing

Techno Proof Waterproofing Experts

SURFACE PREPARATION

The surface to be membrane should be clear from dirt, dry and clean.

TORCH EQUIPMENT

Torch equipments should be properly connected and hoses to be in good working condition.

ROLL ALIGNMENT

No wrinkles should be allowed while laying membrane and proper alignment is necessary

ABOUT SOHARBIT

The Best Reliable Solution For Industries

Over 24 years experience and knowledge of international standards, technological changes and industrial systems, we are dedicated to provide the best and economical solutions to our valued customers.

Delivering the Best Global Industry Services!

Our Meterial 

Specs

ROOF WATERPROOFING

Using Bituminous Waterproofing Membrane Sheet A bituminous waterproofing membrane is used for reinforced concrete roof waterproofing. This waterproofing membrane comes on site in the form of rolls manufactures and packed in the factory properly sealed.

PROCEDURE

Roof Surface Preparation Torch equipments should be properly connected and hoses to be in good working condition. Check the equipment against gas leakage by using soapy water. When torch is opened it should be at lowest possible settings to avoid sudden gush of fire.

MEMBRANE

Compound flow out While torching membrane on joints, approximately 1-inch chemical from the waterproofing membrane should be flowing out to ensure proper filling of gaps. More than 1-inch flow out signals to overheating of membrane.